I just picked up some scuply today, and I completely forgot about the fact that my toys could melt in the oven. I've heard different rememedies on how to overcome this problem i.e. lower the time, temperature, use a blowdryer, etc. Does anyone here have an answer to what I should do?

I've done this before…if you're just adding Sculpy to an existing figure and you're not building up thickness, you can just use a heat gun. Prop the gun up about 12" away from your figure and turn it on for about 30 minutes, rotating the figure in 5 minute intervals. If you have a small rotating base, that would be ideal but it's not necessary. If you're figure is still soft after it cools, heat it again until all the oil is gone. Good luck!